"One-Touch sizes, from 35pt up"

One-Touch magnetic holders in our data run from 35pt up through 180pt, using the same point-based thickness scale as toploaders. A 35pt One-Touch holds a raw or penny-sleeved standard card, and each step up (55, 75, 100, 130, 180pt) adds room for a thicker card, a jersey or patch insert, or a small stack. If you already know what pt a card needs in a toploader, that number carries straight over to a One-Touch.

What the pt number means here

Points measure thickness capacity, the same as with any toploader: one point equals 0.0254mm. A 35pt holder is rated for about 0.89mm, and the 180pt tops out around 4.57mm. A standard trading card on its own runs about 0.305mm thick, roughly 12pt, so even the smallest One-Touch leaves room for a penny sleeve and enough clearance for the magnetic frame to close without pinching the card.

Why the ladder has fewer steps than toploaders

Toploaders come in odd in-between sizes too, since BCW sells its own tiers (59, 79, 108, 138pt) alongside the round Ultra Pro numbers. In our One-Touch data, that split doesn't show up. It's built around the round sizes only, 35 through 180pt, without a second brand's odd-numbered lineup sitting between them. That makes shopping simpler: there's one ladder to compare across brands rather than two overlapping ones.

It's also worth noting that some One-Touch product lines go beyond 180pt for oversized single items outside our data. For a normal trading card, though, you'll rarely need anything past that top tier. If you're seeing a much higher pt number advertised somewhere, it's almost certainly a different holder built for something bulkier than a single card, and worth confirming against the specific product before you buy.

Picking a size

Default to 35pt for anything you'd otherwise put in a 35pt toploader; it's the cheapest tier and covers the majority of cards people actually want to display. Size up only once you've confirmed a card is too thick to close comfortably, a modern foil-heavy card or a jersey insert being the usual suspects. Buying a 180pt for a normal card wastes money on a bigger, heavier holder for no real benefit, and it can leave a thin card rattling loose inside a frame sized for something much thicker.

The decision between reaching for a One-Touch at all versus a plain toploader is really about what happens to the card after it's holdered. A toploader is built for cards that are going into a box or a shipment. A One-Touch is built for a card you're going to pick up, pass around, or leave sitting out, since the magnetic closure means it isn't sliding against plastic every time you handle it. Our full comparison of the two, including when each one wins, is in toploader vs One-Touch.

Quick answers

Do One-Touch holders use the exact same pt sizes as toploaders? In our data, yes for the round numbers: 35, 55, 75, 100, 130, 180pt appear across both. BCW's odd-numbered toploader tiers don't have a direct One-Touch equivalent in what we've measured.

What size One-Touch do I need for a raw modern card? Start at 35pt and move up only if the card doesn't close cleanly. Most modern cards, foil or not, still fit at 35 or 55pt.

Is a higher pt One-Touch better protection? Not automatically. A higher pt rating means more thickness clearance, not a stronger or thicker plastic shell. Buying more pt than the card needs just adds bulk and cost for nothing.

Can I put a double-sleeved card in a One-Touch? Check the thickness math first. A card plus two sleeves adds up fast, and even a 55 or 75pt holder can run out of room; see what does 35pt mean for how the thickness allowance actually breaks down, or check the combo in our fit checker directly.

Buy the tier your card needs and stop there. The One-Touch ladder is short enough, six sizes in our data, that there's rarely a reason to guess high when a quick check against the card's actual thickness settles it in a minute.